2 warnings for the electric connection – EVCO EVF328J9 User Manual
Page 11
EVCO S.p.A.
EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 11 of 62
3.2
Warnings for the electric connection
-
do not use electric or pneumatic screwdrivers on the device terminal board
-
if the device has been taken from a cold to hot place, humidity could condense inside; wait about 1 hour before powering it
-
make sure that the power supply voltage, the frequency and the device electric power, correspond with those of the local
power supply; see chapter 19 “TECHNICAL DATA”
-
disconnect the device power supply before proceeding with any type of maintenance
-
position the power cables as far away as possible from the signal cables
-
the terminating resistor must be connected in order to reduce the reflections on the signal transmitted along the cables that
connect the user interface to the control model.
-
for repairs and information regarding the device, contact the EVCO sales network.