EVCO EVF328J9 - Manual (Page 24)

EVCO S.p.A. EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 24 of 62
Operate as follows to exit the procedure before the operation
is complete:
7. Do not operate for 15 sec (any changes will be
saved).
If the cooking timer is set during the count, this modification
will not be saved.
8.3 Starting cooking timer count
Operate as follows to start the cooking timer count:
1. Ensure that the device is switched on and that no
other procedure is in progress.
2. Press and release the "START/STOP" key: the
“TIMER” LED will switch on and the bottom part of
the “UPPER” display will show the residual count if
the cooking timer.
8.4 Stopping cooking timer count
Operate as follows to stop the cooking timer count:
1. Make sure no procedures are in progress.
2. Hold the “START/STOP” key down for 1 s: the
buzzer will be activated for 3 s, the “TIMER” LED
will switch off and the bottom part of the “UPPER”
display will show “End” flashing for 3 s.
Starting cooking timer count