EVCO EVF328J9 User Manual
Page 45
EVCO S.p.A.
EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 45 of 62
LP
0
2
- - -
2
2
parity
0 = none (no parity)
1 = odd
2 = even
Notes
(1)
The unit of measurement depends on parameter P2.
(2)
Properly set the parameters corresponding to the regulators after setting parameter P2.
(3)
If the duration of the power supply cut-off is less than the time established with parameter r13, on restoring the power
supply, the cooking timer count will be re-proposed (if vice versa, the duration of the cut-off is longer than the time
established with parameter r13, on restoring the power supply, the cooking timer count will be interrupted).
(4)
Steam injection is allowed after the steam temperature has reached that established with the SPS parameter; if steam
injection is not allowed, the “STEAM INJECTION” key will flash.
(5)
During the “energy saving” function, the top output and the floor output are switched on alternately and in cyclic mode for
half of the time established with parameter c1.
(6)
If the cooking timer count is modified and set at zero, it will be interrupted and the buzzer will be activated for 3 s.
(7)
If the device is switched-off when the “energy saving” function is in progress, on successive switch-on the function will not
be re-proposed; if the power supply should be cut-off when the function is in progress, when the same is restored, the
function will be re-proposed and the time count established with c10 will be started from the beginning.
(8)
The parameter differential is 10 °C/18 °F.
(9)
To avoid damaging the unit connected, set the parameter setting when the device is switched off.