EVCO EVF328J9 - Manual (Page 40)

EVCO S.p.A. EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 40 of 62
t0 0 1 - - - 0 0
steam injection activation mode
0 = MANUAL + PERSISTENT MANUAL - pressing and
releasing the “STEAM INJECTION” key will cause
steam injection for time tOn or for the entire
duration that the key is pressed
1 = AUTOMATIC + PERSISTENT MANUAL - pressing
and releasing the “STEAM INJECTION” key will
activate steam injection in cyclic mode
(maximum for the number of nCY cycles or until
the key is pressed and released again; tOn
establishes the duration of injector switch-on
and tOF that of switch-off) or will cause steam
injection for the entire duration the key is
pressed
t3 1 99 °C/°F (1) 5 5 SPS differential (only if P4 = 2)
t4 0 99 °C/°F (1) 50 50
temperature of the steam, below which steam injection
is disabled (relative to SPS, i.e. “SPS - t4”; only if P4 =
2) (4)
t5 0 1 - - - 0 0
enabling the bottom part of the “LOWER” display to
show the residual count of the steam injection number is
cyclic mode (only if t0 = 1)
1 = YES
t6 0 1 - - - 1 1
enabling the quick access to setting the number of
steam injections in cyclic mode (with the procedure
illustrated in the 7.1.3 paragraph; only if t0 = 1)
1 = YES
t8 0 1 - - - 0 0
enabling of the restriction between steam injection in
cyclic mode and start-up of the cooking timer count
(only if t0 = 1)
1 = YES - steam injection in cyclic mode will be
activated at the start of the cooking timer count
t9 0 1 - - - 1 1
enabling of the restriction between steam injection in
cyclic mode and conclusion of the cooking timer count
(only if t0 = 1)
1 = YES - on conclusion of the cooking timer count,
the steam injection in cyclic mode will be
deactivated; press and release the “STEAM
INJECTION” key to activate it again
PARAM. MIN. MAX. U.M. INP. 1 INP. 2 VARIOUS