FingerTec Q2i Manual - Manual (Page 24)

24 CONTENTS
8 • AUTO TEST
Who Should do the Auto Test?
Auto Test page is to diagnose or analyze the conditions in the terminal. There are sever-
al tests available in the Auto Test page and only an administrator is allowed to perform
the test. Before running any tests, kindly contact your reseller for advice or you could
email
[email protected] .
TFT TEST
Test Screen determines the quality and sensitivity of the terminal’s touch screen panel.
You will see lines of different colours; click the screen to continue testing. If there’s a
broken line or distorted colors on the screen, kindly send your FingerTec Terminal for
repair.
To run test : Press Menu > Auto Test icon > TFT Test
AUDIO TEST
Audio Test determines the quality of the terminal’s audio. Every click on the screen will
emit different voice message. If you find any distorted sound in any of the voice mes-
sages or instructions, kindly send your terminal for checking and repair.
To run test : Press
Menu > Auto Test icon > Audio Test.
KEYBOARD TEST
The Keyboard Test is for you to check the condition of the keyboard. Press Menu > Auto
Test icon > Keyboard Test
SENSOR TEST
This test is to determine the condition of the fingerprint optical scanner you need to run
fingerprint test. Once you run the sensor test, the terminal will display a white square on
the screen. Place your finger on the scanner. If you can see your fingerprint on the white
square, the optical scanner works fine. Otherwise, kindly send your terminal for check-
ing and repair.
To run test : Press Menu > Auto Test icon > Sensor Test
RTC TEST
Time is an essence in any FingerTec terminal and it should not be compromised. The
RTC Test will display date, time, 0 (s): 0 (ms)
Click the screen to start the test. The 0 (s): 0 (ms) will start to run and every 10ms change
the second to 1. If it doesn’t run as it should, kindly send your terminal for checking and
repair.
To run test : Press Menu > Auto Test icon > RTC Test