FingerTec Face ID 2 (FEM 800) Manual - Manual (Page 13)

14 CONTENTS
Ingress Online Activation
Ingress is a genuine software by FingerTec. Every FingerTec ac-
cess control model comes bundled with a unique license key.
To start using the terminal with Ingress, you must connect the
terminal to Ingress and perform online activation. Ingress reads
the serial number of your terminal and sends it for verification
at the FingerTec server via Internet.
In case you do not have an Internet connection, you would
need to do offline activation. Please send the serial number
and models of your terminals to your local resellers or
support@
fingertec.com to request for a product key and activation key.
Installation and Setup of Ingress
Install Ingress in a PC that fulifills Ingress’ minimum require-
ments. Refer to
http://www.fingertec.com/customer/download/
postsales/SUM-Ingress-E.pdf for the Ingress user guide online.
Setup Wizard will require you to do online activation before
connection establish between Ingress and terminals.
Connecting the Terminals to Ingress
DETERMINING TERMINAL NUMBER: Identify the number of your
terminals to differentiate them between one another. Ingress can con-
nect up to 999 units of terminal. Press Menu > Options > Comm Opt >
Dev Num > Select the number.
USING TCP/IP: IP address is important, as it is a unique address of the
terminal in LAN. Without the IP address, locating the specific terminal
is not possible. To input the IP address of the terminal: Press Menu >
Options > Comm Opt > IP Addr > Key in IP address.
USING TCP/IP: It is important to setup the Ethernet to connect the
terminals using TCP/IP connection. Setting up the Ethernet is done by
enabling the Ethernet function: Press Menu > Options > Comm Opt >
Ethernet > Yes. Turn off the terminal after you have set the Ethernet setting
to Yes. Now, plug-in the network plug to the Ethernet interface and turn the
power on. Determining the Netmask, Gateway and NetSpeed: For TCP/IP
connection, please configure the netmask, gateway and netspeed for the
terminal.
Press Menu > Options > Comm Opt > NetMask > Insert the numbers.
Press Menu > Options > Comm Opt > Gateway > Insert the numbers.
Press Menu > Options > Comm Opt > NetSpeed > Choose the speed of your Ethernet
connection.
USING RS232 CONNECTION: For connection via RS232,baudrate is the de-
terminant of communication speed between the terminal and the software.
The higher the baudrate, the faster the speed is. To turn on RS232 connec-
tion and set the baudrate: Press Menu > Options > Comm Opt > RS232 >
Change the RS232 connection to Y. To change baudrate: Press Menu >
Options > Comm Opt > Baudrate > Change the Baudrate accordingly.
USING RS485 CONNECTION: For connection via RS485, baudrate is also
the determinant of communication speed between the terminal and the
software but the speed must be according to the speed of the converter.
Check your converter for the speed. To turn on RS485 connection and
set the baudrate: Press Menu > Options > Comm Opt > RS232 > Change
the RS485 connection to Y. To change baudrate: Press Menu > Options >
Comm Opt > Baudrate > Change the Baudrate accordingly.
Using USB to Download/Upload Data
A USB flash disk is useful in cases where the terminal is installed far
from a PC or there is a connection problem. To determine the type
of USB flash disks compatible with the terminal, please refer to this
link at fingertec.com/newsletter/HL_74.html using USB
Press Menu > PenDrive Mgmt > Choose the operation that you
want to carry out via USB flash disk.
Communication Key
Since the software is controlled by an activation code and a prod-
uct key, set the COMM key to zero. Press Menu > Options > Comm
Opt > COMM Key > Set to 0.