Descriptions of available connections, Usb port, Tcp/ip port – FingerTec Face ID 3 Manual User Manual
Page 13: Power supply port, Rs485/wiegand input connection port
1
1
8
TOP
FRONT
1
8
joint 1 pin
joint 2 pin
TX+ 1
•
•
RX+
TX- 2
•
•
RX-
RX+
•
•
1 TX+
RX-
•
•
2 TX-
Descriptions of Available Connections
UsB port
Linking with USB flash disk for remote data transfer.
tCp/ip port
Connect with a CAT5 cable for LAN connection, one end to terminal’s port and an-
other end to the computer’s TCP/IP Port.
TCP/IP for Single Connection
Linking the terminal to a single computer using TCP/IP
requires Ethernet 10/100Base-T Crossover Cable. The
cable can be used to cascade hubs or to connect Ether-
net stations back-to-back without a hub. It works with
both 10Base-T and 100Base-TX.
TCP/IP for Network Connection
Linking the terminals to multiple computers using TCP/IP requires Ethernet 10/100Base-T Straight Thru
Cable or “whips”. The cable works with both 10Base-T and 100Base-TX, connecting a network interface
card to a hub or network outlet.
power sUppLy port
Insert the Power Adapter point to this port for power.
rs485/wiegand inpUt ConneCtion port
RS485 Single Connection:
Connection to a single computer using RS485 wire.
RS485 Network Connection:
Connection to multiple computers using Daisy Chain connection.
Wiegand Output:
Connecting with third party connector or terminal(s).
ConneCtor pin
CaBLe CoLor
ConneCtor
TX+
1
•
White/Orange
•
1
TX+
TX-
2
•
Orange
•
2
TX-
RX+
•
White/Green
•
RX+
4
•
Blue
•
4
5
•
White/Blue
•
5
RX-
•
Green
•
RX-
•
White/Brown
•
8
•
Brown
•
8