FingerTec Face ID 3 Manual - Manual (Page 30)

0
12 • ACCESS
Most Commonly Used Access Features
The Face ID  can be connected to door access accessories like electromagnetic
lock and doorbolt to control access to doors. FingerTec provides all kinds of door-
lock accessories which can be viewed at accessory.fingertec.com. Under Access
Control Parameter In Access icon, you can configure 4 most common used func-
tion, which are explained below. To access to Access Control Parameter: Menu >
System > Access Control Settings > Access Control Parameter
how Long it taKes BeFore the door LoCKs again
(Lock Delay)
This value is the time period for the door to lock again after it unlocks on a success-
ful verification. The default value is 10 seconds and the range is between 1 to 10. A
tap on the value will prompt a keypad. Input the value in seconds.
deLaying door sensor
(Door Sensor Delay)
This function only works if a door sensor is available. When a door does not close
for a specified time, the sensor will trigger alarm system. Specify the time of the
delay. Default value is 10s, the range is 0-99 s. A tap on the value will prompt a
keypad. Input the value in seconds.
Choosing door sensor type
(Door Sensor Mode)
There are two types of door sensors available for door access which are Normally
Open (NO) and Normally Close (NC). Once a door sensor is available, you have to
choose the door sensor type. Default is None.
deLaying aLarM
(Alarm Delay)
This function only works when there is alarm system installed with Face ID . You
can adjust the time before Face ID  triggering an alarm system if the door is not
closed. A tap on the value will prompt a keypad. Input the value in seconds. The
default value is 0s.
Door Access by Time Control
tiMe Zone
The period where a user is allowed access is called TIME ZONE or time period (TP).
In total there are 50 time zones available in the Face ID . Each Time Zone has 
time slots for Monday until Sunday. To define time zone: Press Menu > System >
Access
Control Settings > Time Zone Settings > Select the Time Zone number and deter-
mine the time for each day.