FingerTec Face ID 3 Manual - Manual (Page 15)

15
Determining the Netmask, Gateway and NetSpeed: For TCP/IP connection,
please configure the netmask, gateway and netspeed for the terminal.
Press Menu > Options > Comm Opt > NetMask > Insert the numbers.
Press Menu > Options > Comm Opt > Gateway > Insert the numbers.
Press Menu > Options > Comm Opt > NetSpeed > Choose the speed of your Eth-
ernet connection.
Using rs232 ConneCtion
For connection via RS22,baudrate is the determinant of communication speed be-
tween the terminal and the software. The higher the baudrate, the faster the speed is.
To turn on RS232 connection and set the baudrate: Press Menu > Options >
Comm Opt > RS22 > Change the RS22 connection to Y.
To change baudrate: Press Menu > Options > Comm Opt > Baudrate > Change
the Baudrate accordingly.
Using rs485 ConneCtion
For connection via RS485, baudrate is also the determinant of communication
speed between the terminal and the software but the speed must be according to
the speed of the converter. Check your converter for the speed.
To turn on RS485 connection and set the baudrate: Press Menu > Options >
Comm Opt > RS22 > Change the RS485 connection to Y.
To change baudrate: Press Menu > Options > Comm Opt > Baudrate > Change
the Baudrate accordingly.
Using USB to Download/Upload Data
A USB flash disk is useful in cases where the terminal is installed far from a PC or
there is a connection problem. To determine the type of USB flash disks compat-
ible with the terminal, please refer to this link at
http://www.fingertec.com/newsletter/HL_4.html using USB
Press Menu > PenDrive Mgmt > Choose the operation that you want to carry out
via USB flash disk.
Communication Key
Since the software is controlled by an activation code and a product key, set the
COMM key to zero. Press Menu > Options > Comm Opt > COMM Key > Set to 0.