FingerTec Face ID 3 Manual - Manual (Page 14)

14
note
Link all cables to the correct connection point(s) before attempting to connect the
terminals to software.
aCCess ConneCtion
Links the terminal to a door lock system.
BeLL port
Links the terminal to doorbell.
Ingress Online Activation
Ingress is a genuine software by FingerTec. Every FingerTec access control model
comes bundled with a unique license key. To start using the terminal with Ingress,
you must connect the terminal to Ingress and perform online activation. Ingress
reads the serial number of your terminal and sends it for verification at the Fin-
gerTec server via Internet.
In case you do not have an Internet connection, you would need to do offline acti-
vation. Please send the serial number and models of your terminals to your local re-
sellers or [email protected] to request for a product key and activation key.
Installation and Setup of Ingress
Install Ingress in a PC that fulifills Ingress’ minimum requirements. Refer to
http://www.fingertec.com/customer/download/postsales/SUM-Ingress-E.pdf
for the Ingress user guide online. Setup Wizard will require you to do online activa-
tion before connection establish between Ingress and terminals.
Connecting the Terminals to Ingress
deterMining terMinaL nUMBer
Identify the number of your terminals to differentiate them between one another.
Ingress can connect up to 999 units of terminal. Press Menu > Options > Comm Opt
> Dev Num > Select the number.
Using tCp/ip
IP address is important, as it is a unique address of the terminal in LAN. Without
the IP address, locating the specific terminal is not possible. To input the IP ad-
dress of the terminal: Press Menu > Options > Comm Opt > IP Addr > Key in IP
address.
Using tCp/ip
It is important to setup the Ethernet to connect the terminals using TCP/IP connec-
tion. Setting up the Ethernet is done by enabling the Ethernet function: Press
Menu > Options > Comm Opt > Ethernet > Yes.
Turn off the terminal after you have set the Ethernet setting to Yes. Now, plug-in
the network plug to the Ethernet interface and turn the power on.