Interlogix GE-DS-242-PoE User Manual
Page 136
Chapter 5: Console Management
132
GE-DS-242-PoE Managed Ethernet Switch User Manual
The previous commands would apply the follow settings for the Switch.
IP: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.254
Figure 5-3: Set IP address screen
2. Repeat Step 1 to check if the IP address is changed.
If the IP is successfully configured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of Managed
Switch through the new IP address.
NOTE:
If you are not familiar with console command or the related parameter,
enter "help" anytime in console to get the help description.
You can change these settings, if desired, after you log on. This management
method is often preferred because you can remain connected and monitor the
system during system reboots. Also, certain error messages are sent to the serial
port, regardless of the interface through which the associated action was
initiated. A Macintosh or PC attachment can use any terminal-emulation program
for connecting to the terminal serial port. A workstation attachment under UNIX
can use an emulator such as TIP.