Interlogix GE-DS-242-PoE - Manual (Page 147)

Chapter 6: Command Line Interface
GE-DS-242-PoE Managed Ethernet Switch User Manual 143
Trunk Configuration
Trunk allows the switch to combine ports so that they function like a single high-
speed link. It can be used to increase the bandwidth to some devices to provide
a high-speed link. For example, trunk is useful when making connections
between switches or connecting servers to the switch. Trunk can also provide a
redundant link for fault tolerance. If one link in the trunk failed, the switch can
balance the traffic among the remaining links.
NOTE: The 10/100 Mbps port cannot be trunked with gigabit port (port 25~26).
All ports in the same trunk group will be treated as a single port. If a trunk group
exists, the ports belonging to that trunk will be replaced by "TRUNK #" in the
VLAN configuration screen. The following example configures port 25~26 as
"TRUNK 1."
Trunking Commands
show trunks
Description:
Show trunking information.
Switch(config)# show trunk
Group ID | LACP | Ports | LACP Active
--------------+--------+-------------------+-----------------
1 | Yes | 23,24 | 23,24
trunk add
Description:
Add a new trunk group.
Syntax:
trunk add <trunk-id> <lacp | no-lacp> <port-list> <active-port-list>
Parameters:
<trunk-id> specifies the trunk group to be added.