Interlogix GE-DS-242-PoE - Manual (Page 149)

Chapter 6: Command Line Interface
GE-DS-242-PoE Managed Ethernet Switch User Manual 145
no lacp system-priority
Description:
Set LACP system priority to the default value 32768.
show lacp status
Description:
Show LACP enable/disable status and system priority.
show lacp
Description:
Show LACP information.
Switch(config)# show lacp status
LACP is enabled.
LACP system priority: 32768
show lacp agg
Description:
Show LACP aggregator information.
Syntax:
show lacp agg <trunk-id>
Parameters:
<trunk-id>
specifies the trunk group to be shown.
show lacp port
Description:
Show LACP information by port.
Syntax:
show lacp port <port-id>
Parameters:
<port-id>
specifies the port to be shown.
NOTE: If VLAN group exists, all of the members of static trunk group must be in
same VLAN group.