Juniper Systems Allegro CX Manual - Manual (Page 263)

Allegro CX Owner’s Manual 263
An Initializing Bar Code Scanner message box pops up, as the
Bar Code Reader program loads and the Bar Code Reader program
opens.
Tap on the Bar Code Setup button.
Bar Code Setup
Before you begin scanning, use the Bar Code Setup program to
confi gure the bar code scanner according to your needs. The Bar
Code Setup options are described throughout this section.
The Bar Code Setup program has the following fi ve tabs for
personalizing your bar code scanning program:
User
Scanner
Data Format
Code Type
Defaults
The Bar Code Setup program has many options that are enabled and
disabled by tapping on small boxes next to the option. When an
option is selected, a checkmark appears in the box. When the option
is disabled, the checkmark disappears.
To set up and save your bar code scanning options, complete the
following steps:
Read the following set up sections: User, Scanner, Data Format,
Code Type, and Defaults.
3)
▲
‰
‰
‰
‰
‰
1)