Sears 38512102 - Manual (Page 58)

Buttonhole (Continued)
(Bar-tack)
[U Raise the needle, set the stitch length dial at “0” and stitch
width dial at “5". Sew 5 stitches of the bar-tack and stop
the machine with the needle in the left position.
0 Leave the needle at the left needle position in the fabric
and raise the presser foot so that you can turn the fabric
180 degrees.
(Line tack)
d] Raise the needle, set the stitch length dial at “O S” and
stitch width dial at “2". Slide the fabric to the right so that
the needle is at the “A" position, as shown.
I Sew the left side of the BH the same length as the right
side then stop the machine.
jSet the stHch length dial at “0" and stitch width dial at “0".
Sew several stitches for the lock-stitch.
Ф Stitch length dial: 0
d) Stitch width dial; 0
11 Insert a pin at the end fo the buttonhole, then cut the
opening with a seam ripper. Take care not to cut the
stitches.
50