SINGER 814 Stylist User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ACCESSORIES (Continued)
Shank
Foot
CHANGING PRESSER FEET
The presser feet that are supplied with
your machine snap on and off a common
shank. To change thefoot:
1. Raise presser-foot lifter and turn hand
wheel toward you to raise needle to its
highest position.
2. Press toe of presser foot upward (as
far as it will go) and then snap down to
remove the foot.
3. Center the new presser foot under the
shank and lower the presser-foot lifter
so that the shank fits over the presser-
foot pin.
4. Press down on presser-foot screw until
foot snaps Into place.
To
remove
the
complete
foot
(with
shank), as for free-motion darning or
embroidery, see page 56, loosen the
presser-foot screw and remove shank and
foot together.
CHANGING NEEDLE PLATES
1. Raise needle to its highest position and
raise the presser-foot lifter (you do not
need to remove the presser foot).
2. Open slide plate with downward finger
pressure. Draw plate toward you, open
ing It
all the way to
raise the locking pin
that holds the needle plate in place.
3. Place thumb under right side of needle
plate; lift and withdraw plate to the
right.
4. Insert new needle plate under locking
pin and over positioning pin.
5. Close slide plate to lower locking pin
and secure the needle plate.
8