SINGER 814 Stylist User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This machine is designed to use a 15 watt maxi
mum light bulb.
CHANGING
CAUTION:
THE LIGHT BULB
Before
removing
bulb,
disconnect
power-line
plug from electrical sup
ply.
Removing the Bulb
With thumb and forefinger lower the
light bracket. Do not attempt to unscrew
bulb. Press it up into socket and at same
time turn bulb over in direction shown to
unlock bulb pin.
Replacing the Bulb
Press new bulb into socket with bulb pin
entering slot of socket and turn it over in
direction shown to lock bulb in position.
Push bracket back into recess.
Locks
Unlocks
This machine
is designed to
use a 15 watt
maximum light
bulb
Changing the
Light
Bulb
REPLACING THE SLIDE PLATE
You will not have any occasion to remove
the slide plate. However, if it should
accidentally become disengaged from the
machine, it is easily replaced.
@ Raise presserfoot and needle.
® Place slide plate in slideway with the
front edge close to, but not covering,
the retaining spring (as shown in
illustration).
® With a screwdriver, lift each end of the
spring into each of the side grooves on
the underside of the slide plate.
® Draw the plate gently toward you and
fully engage the spring.
® Close slide plate.
Raise Presser Foot
and Needle
Lift Retaining
Spring into Slide
Plate Grooves
Replacing the Slide Plate
59