Preliminary steps – SINGER 814 Stylist User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Power and Light
/Switch
preliminary steps
COMNECTIMG
THE MACHINE
Before plugging in your machine, be sure
that the voltage and number of cycles
indicated on the plate under the hand
wheel conform to your electrical power
supply.
Push the machine plug into the receptacle
at the right end of the machine bed. Then
connect the power-line plug to your
electrical outlet.
ON
OFF
Power and Light Switch
Speed Controller
OPERATING
MACHINE AND
CONTROLLER
To
turn
on
both
machine
and
sewing
fight,
press power and light switch to
ON position (red bar on switch will be
visible). To turn off machine and light,
press switch at red bar to OFF position.
CAUTION:
We recommend that you
turn off the power and light switch before
changing needles, presserfeet, and needle
plates and when leaving the machine
unattended. This eliminates the possibility
of starting the machine by accidently
pushing the speed controller.
To run the machine,
press the speed
controller. The harder you press, the
faster the machine will sew.
To
stop
the
machine
from
sewing,
remove pressure from speed controller.
10