Removing bobbin case, face plate and bulb – SINGER 814 Stylist User Manual
Page 60
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARING FOR YOUR MACHINE (Continued)
Position Plate
Face Plate
Top
Cover
removing bobbin case,
face plate and bulb
CAUTiOW: Before removing bobbin
case, face plate and light
bulb, disconnect po’wer-
iine plug from electrical
supply.
REMOVING AND
REPLACING
BOBBIN CASE
® Raise the presser foot.
® Turn hand wheel toward you until
needle is above the presser foot.
• Remove needle plate as instructed on
page 9.
® Remove bobbin.
To remove bobbin case,
turn bobbin case
holder to back as far as it will go. Lift out
bobbin case.
To replace bobbin case,
guide the forked
end under the feed and then draw the
bobbin case under the position plate as
illustrated. Turn holder all the way forward
to lock bobbin case in position. After lock
ing bobbin case in position, check that
bobbin case is not jammed, but has slight
rotational movement.
® Replace needle plate.
® Fully close slide plate to lower the
needle plate locking pin and secure the
needle plate.
REMOVING FACE PLATE
• Loosen and remove screw and remove
face plate by sliding it downward.
REPLACING FACE PLATE
® Slide face plate up so that rim is en
gaged under edge of top cover.
® Align screw hole at lower edge of plate
with screw hole in machine and replace
and tighten screw.