SINGER 814 Stylist User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
® Place spool of thread on spool pin.
Snap thread in the thread guide post
then lead thread around bobbin winder
tension disc, as illustrated above.
® Pass thread, from the inside, through
hole in bobbin and place bobbin on
spindle.
® Push bobbin and spindle to the right
to engage the bobbin winder. Hold
thread end as shown and start the
machine, winding at moderate speed.
® Cut off thread end after a few coils
have been wound on the bobbin.
© When required amount of thread has
been wound (winding will stop when
bobbin is full), stop machine. Cut con
necting thread.
® Push bobbin and spindle toward the
left to disengage bobbin winder. Re
move bobbin.
® Press hand wheel disc for sewing.