SINGER 513 Stylist User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THE BOBBIN THREAD (Continued)
Bobbin Winder Switch
Place thread spool on spool pin over
felt. Lead thread around bobbin winder
tension disc and through small hole in
bobbin (from the inside).
Place bobbin on holder and turn bobbin
winder switch to WIND,
Tightening Hand Wheel Knob
Hold thread as shown and start the
machine, winding at moderate speed.
Cut off thread end when winding is
well under way.
When required amount of thread has
been wound (winding will stop by
itself when bobbin is full), stop the
machine and cut connecting thread.
Turn bobbin winder switch to SEW
and remove bobbin from holder.
Tighten hand v\/heel knob.
12