SINGER 513 Stylist User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This machine is designed to use a 15 watt
maximum light bulb.
THE LIGHT BULB
Disconnect power-line plug from elec
trica! supply.
With thumb and forefinger lower the light
bracket. Do not attempt to unscrew bulb.
Press it up into socket and at same time
turn bulb over in direction shov/i/n to
unlock bulb pin.
tine Byiib
Press new bulb into socket, with bulb pin
entering slot of socket, and turn it over in
direction shown to lock bulb in position.
Release bracket, and entire assembly will
snap back into recess.
Unlocks
This machine
is designed to
use a 1 5 watt
maximum light
bulb
THE SLIDE PLAT!
You
W i l l
not have any occasion to remove
the slide plate. However, if si should
accidentally
become
disengaged
from
the machine, it is easily replaced.
® Raise presser foot and needle.
® Place slide plate sn sisdeway with the
front edge close to, but not covering,
the retaining spring (as shown in illu-
sirailon).
® With a screwdriver, lift each end of the
spring into each of the side grooves on
the underside of the slide plate.
® Draw the plate gently toward you and
fully engage the spring.
® Close slide plate.
Raise Presser Foot
and Needle