SINGER 513 Stylist - Manual (Page 9)

FEEO^COVER WEEDLE PLATE
The feed-cover needle plate is used in
place of the general purpose needle plate
when fabric feeding is not desired. Use
it for button sewing (page 31) and free-
motion darning (page 51).
CHAWOiWG WEEDLE PLATE
® Raise presser foot. (You do not need
to remove the foot.)
Turn hand wheel toward you
needle is in its highest position.
until
Open slide plate with downward finger
pressure. Draw plate toward you, open­
ing it aH the way to raise the needle
plate locking pin and unlock the needle
plate.
Place thumb under needle plate and
draw plate to the right to remove.
Insert new needle plate under locking
pin and over positioning pin.
Close slide plate to lower locking pin
and secure the needle plate.
PRESSER FEET
The presser feet that are supplied with
your machine snap on and off a common
shank. To change the foot:
® Raise presser-foot lifter and turn hand
wheel toward you to raise needle to its
highest position.
® Press toe of presser foot upward (as
far as it will go) and then snap down
to remove the foot.
® Center the new presser foot under the
shank and lower the presser-foot lifter
so that shank fits over the presser-foot
pin.
@ Press down on presser-foot screw until
foot snaps into place.
Needle Plate Positioning Pin
Shank
Foot
Changing Presser Foot
7