SINGER 513 Stylist - Manual (Page 35)

Two stitch width settings are required for rnaking buttonholes: one for side
stitching and one for the bar tack. Two possible combinations are illustrated.
STITCH WIDTH
Selector Setting
for Side Stitching
Selector Setting
for Bar Tack
Selector Setting
for Side Stitching
Selector Setting
for Bar Tack
Procedyre
Set flexI-Stitch dial at 0 and set siiich
length in FINE area of stitch length dial.
Attach special purpose foot.
Set the pattern selector at g , needle
position selector at , and stitch width
selector at the width desired for the side
stiichifig. Place work under needle, align­
ing center marking of buttonhole with
center slot In the special purpose foot.
Side Stitciimg
Position needle in fabric at point
Lower foot and siiich to end of marking.
Leave needle in fabric at point B. Raise
foot and pivot work on needle. Lower
foot. Take one stitch without changing
width setting, bringing work to point C.
Adjust stitch width selector for bar tacks
and take at least six stitches. Stop at point
33