Slant overedge stitch (left), Punto sobreorillado inclinado (izquiettia), Feglcl – SINGER 5818 User Manual

Page 50: Slant overedge stitch, Punto sobreorillado inclinado, Surjet

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Slant overedge stitch

(Left)

Seams in knitted and stretch fabrics can be joined
and finished in one operation when you use the
slant overedge stitch (left).

• Baste the garment together on the seam line

allowing for a 5/8” seam allowance and fit in the

usual way.

Required settings
Stitch Selection: Slant Overedge

Needle Position:

feglcl

Stitch Width: j

Stitch Length: mark (|)
Foot: General Purpose (B)
Needle Plate: General Purpose (A)

• After making any adjustments, trim the seam

edge evenly to a 1/4” from the seam line basting.

• Place trimmed seam under the foot so that the

straight stitches fail on the basted seam line and
the zig-zag stitches fall over the seam edge.

Punto sobreorillado
inclinado

(Izquiettia)

Las costuras en tejidos de punto y elásticos pueden
unirse y rematarse en una sóla operación,
utilizando el punto de sobreorillado inclinado
(izquierda).

• Hilvane las prendas juntas sobre la línea de

costura dejando un borde de 16mm (5/8”) y
ajústelo en la forma usual.

Posiciones requeridas
Selección punto: Sobreorillado inclinado

Posición aguja: fe

c

I

d

d)

Anchura punto: j \

Longitud punto: símbolo ( | )
Prénsatelas: Uso general (B)

Plancha aguja: Uso general (A)

• Antes de hacer cualquier ajuste, corte los bordes

de costura por igual a 6mm (1/4”) de la línea de
costura hilvanada.

• Coloque la costura ya recortada debajo del

prénsatelas de manera que los puntos rectos

caigan sobre la línea de costura hilvanada y los
puntos en zig-zag caigan sobre el borde de la
costura.

48

Surjet

(Gauche)

Vous pouvez en une seule opération coudre et
surjeter les coutures des tissus extensibles, jerseys
et tricots.

• Bâtissez l’ouvrage sur la ligne de couture en

laissant une valeur couture de 1,5 cm.

Réglages recommandés
Sélecteur de point: Surjet

Position d’aiguille: fe cfe d

Largeur de point:

j |

Longueur de point: symbole ( | )
Pied presseur universel (B)
Plaque à aiguille universelle (A)

Recoupez la couture à 6mm de la ligne de piqûre.

Placez la couture sous le pied presseur pour que

les points droits tombent sur le bâti de la couture

et les points zig-zag sur le bord de la couture.

Advertising