Inserting a bobbin – SINGER 2517 Merritt User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Inserting a bobbin
• Raise presser foot.
Turn hand wheel toward you until needle is in its
• Open slide plate and remove empty bobbin.
1. Pull 4” (10 cm) of thread from replacement bobbin
and insert bobbin into case, as shown.
Holding bobbin in place, guide thread into notch (1)
and then down the slot to the left and guide around
into notch (2).
Draw several inches of thread diagonally across the
bobbin toward the back of the machine.
4. While holding thread on outside, close the slide plate,
allowing thread to extend through the slot between
the slide plate and needle plate.