Threading the machine, Singer – SINGER 2517 Merritt User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the machine
® Raise take-up lever to highest position by
turning hand wheel toward you.
• Place spool of thread on spool pin.
Slide spool cap firmly over rim of spool to
prevent thread tangling.
Lead thread from spool and snap into
thread guide (1) and with only one hand
pass the thread under the guide and
through the slot, as illustrated (2).
® Thread the tension discs by leading the
thread down and around the tension (3).
Hold the spool lightly and pull the thread
up, lifting the spring and allowing the
thread to slip into thread guard.
o Slip thread into take-up lever as illustrated
® Pass thread through guides (5) and (6).
Thread needle from front to back, pulling
4” (10cm) of thread through eye (7).