SINGER 2517 Merritt - Manual (Page 57)

SINGER
■
Attaching a button
Recommended settings
stitch Selection: Zig-Zag Stitch
Needle Position: ¿3 cL czl
stitch Width: To suit Button
Foot: Button Sewing (H) (Optional)
Needle Plate: General Purpose (A)
Attach Feed Cover (F)
Note: Before you can attach a button, the bobbin thread
must be brought up through the hole in the feed
cover.
1. Set stitch width at ( i ), and needle position selector
at ( ¿3 ). Position button under foot and lower the
needle into the center of the left hole. Lower the
foot. Turn hand wheel toward you until needle rises
out of button and is above the foot.
2. Move stitch width selector until needles is over the
other hole in the button. Then, when you begin to
stitch, the needle should enter into the right hole of
the button. Take six or more zigzag stitches to attach
button and finish with the needle on the left side.
3. To fasten stitching, adjust width to ( i ) and take
three or four stitches. Remove work, draw threads to
underside, fasten, and trim.
J
.1 ^
2 AAAAA ® s o ®
o
2 AWvA
3 AAAAA 1 2 3 4 5 3 AAAAA
4 AAAAA 4AAAAA
5 AAAAA 5AAAAA