ADLINK ND-6018 - Manual (Page 43)

Command Set • 35
Write Source High/Low
Values for Linear
Mapping
$(Addr)6(Data_L)(Data_H) 6014D 3-34
Write Target High/Low
Values for Linear
Mapping
$(Addr)7(Data_L)(Data_H) 6014D 3-35
Enable/Disable Linear
Mapping
$(Addr)A(Status) 6014D 3-36
Read Enable/Disable
Linear Mapping Status
$(Addr)R 6014D 3-37
CJC Offset Calibration $(Addr)9(Counts)
6011/D,
6018
3-38
Clear Latch Alarm @(Addr)CA
6011/D,
6012/D,
6014D
3-39
Clear Event Counter @(Addr)CE
6011/D,
6012/D,
6014D
3-40
Disable Alarm @(Addr)DA
6011/D,
6012/D,
6014D
3-41
Read Digital I/O and
Alarm Status
@(Addr)DI
6011/D,
6012/D,
6014D
3-42
Set Digital Output @(Addr)DO(OutData)
6011/D,
6012/D,
6014D
3-44
Enable Alarm @(Addr)EA(Mode)
6011/D,
6012/D,
6014D
3-45
Set High Alarm @(Addr)HI(Data)
6011/D,
6012/D,
6014D
3-46
Set Low Alarm @(Addr)LO(Data)
6011/D,
6012/D,
6014D
3-47
Read Event Counter @(Addr)RE
6011/D,
6012/D,
6014D
3-48
Read High Alarm @(Addr)RH
6011/D,
6012/D,
6014D
3-49
Read Low Alarm @(Addr)RL
6011/D,
6012/D,
6014D
3-50