ADLINK ND-6018 - Manual (Page 86)

78 • Command Set
3.40 Read Leading Code Setting
@Description
Read command leading code setting and host watchdog status.
@Syntax
~(Addr)0<CR
>
~ Command leading code.
(Addr) Address ID
0 Read command leading code setting.
@Response
!(Addr)(Status)(C1)(C2)(C3)(C4)(C5)(C6)<CR>
or
?(Addr)<CR
>
! Command is valid.
? Command is invalid.
(Addr) Address ID
(Status) (2-character)
Bit 0: Reserved
Bit 1: Power failure or watchdog failure
Bit 2: Host watchdog is enable
Bit 3: Host failure
(C1) Leading code 1, for read configuration status,
firmware version, etc. default is $.
(1-character)
(C2) Leading code 2, for read synchronize sampling,
digital output, default is #.
(1-character)
(C3) Leading code 3, for change configuration.
default is %. (1-character)
(C4) Leading code 4, for read alarm status, enable alarm,
etc. default is @. (1-character)
(6011/D, 6012/D, 6013
6014D, 6017, 6018)