ADLINK ND-6024 - Manual (Page 29)

Command Set • 23
3.2. Set Configuration
@Description
Configure the basic setting of NuDAM, including the address ID, output
signal range, baud rate, and data format. The new configuration will be
available after executing the command.
@Syntax
%(OldAddr)(NewAddr)(OutputRange)(BaudRate)(DataFormat)<CR>
% Command leading code. (1-character)
(OldAddr)
NuDAM module original address ID. The
default address ID of a brand new module is
01. The value range of address ID is 00 to FF
in hexadecimal. (2-character)
(NewAddr)
New address ID, if you don’t want to change
address ID, let new address ID equals to the
old one. (2-character)
(OutputRange)
Define analog output range, refers to Table
3-1 for details. (2-character)
(BaudRate)
Define communication baud rate, refers to
Table 3-2 for details. (2-character)
(DataFormat)
Define checksum, integration time and
output data format, refers to Figure 3-1 for
details. (2-character)
@Response
!(Addr)<CR>
or
?(Addr)<CR>
(Addr) Address ID.
! Command is valid.
? Command is invalid, parameter values are invalid,
or change the setting without grounding the
DEFAULT* pin.
Note : When you want to change the checksum or baud rate, the DEFAULT*
pin must be grounded at first.
@Example