Subaru 2013 Impreza - Manual (Page 178)

Black plate (180,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
3-60
Instruments and controls
then pull the “ /SET” switch toward you.
3. The current setting is displayed. Pull
the
“ /SET” switch toward you to enter
the selection mode.
4. Select the preferred setting by operat-
ing the
“ ” or “ ” switch, and then pull
the “ /SET” switch toward you.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the
“ /SET” switch toward you.
6. The system will notify you that the
setting is complete for approximately 3
seconds.
If the setting is not available, the following
notification will be displayed for approxi-
mately 3 seconds. For more details,
contact a SUBARU dealer.
& Initialize
Items that have been set to your pre-
ference can be initialized. To select an
initialization menu, operate the
“ ” or “ ”
switch as follows.
! Preparation for initialization
1. Turn the ignition switch to the
“ON”
position, and then pull the “ /SET” switch
toward you for more than 2 seconds.