Subaru 2013 Impreza - Manual (Page 95)

Black plate (95,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
stantly, the immobilizer system does not
impede normal starting of the engine.
If the engine fails to start, pull out the key
once before trying again. Refer to
“Ignition
switch ” F3-3.
This device complies with Part 15 of
the FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the
following two conditions: (1) this de-
vice may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
CAUTION
. Do not place the key under direct
sunlight or anywhere it may
become hot.
. Do not get the key wet. If the key
gets wet, wipe it dry with a cloth
immediately.
NOTE
To protect your vehicle from theft,
please pay close attention to the fol-
lowing security precautions:
. Never leave your vehicle unattended
with its keys inside.
. Before leaving your vehicle, close all
windows and the moonroof, and lock
the doors and rear gate.
. Do not leave spare keys or any
record of your key number in the
vehicle.
&
Security indicator light
Refer to “Security indicator light” F3-21.
& Key replacement
Your key number plate will be required if
you ever need a replacement key made.
Any new key must be registered for use
with your vehicle
’s immobilizer system
before it can be used. Up to four keys
can be registered for use with one vehicle.
One key that has already been registered
is required in order to register a new key.
If you lose a key, the lost key ’s ID code still
remains in the memory of the vehicle ’s
immobilizer system. For security reasons,
the lost key
’s ID code should be erased
from the memory. To erase the lost key ’s
ID code, all keys that will be used are
required.
For details about new key registration and
erasing the lost key
’s ID code, contact
your SUBARU dealer.
Door locks
& Locking and unlocking from
the outside
NOTE
If you unlock the driver ’s door with a
key and open the door while the alarm
system is armed, the alarm system is
triggered and the vehicle
’s horn
sounds. In this case, perform any of
the following operations.
. Press any button on the remote
transmitter.
. Insert the key into the ignition
switch and turn the ignition switch to
the
“ON” position.
For details about the alarm system,
refer to
“Alarm system” F2-12.
Keys and doors
2-3
– CONTINUED –
2