Subaru 2013 Impreza - Manual (Page 181)

Black plate (183,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
7. The system will notify you that the
setting is complete for approximately 3
seconds.
Light control switch
CAUTION
. Use of any lights for a long period
of time while the engine is not
running can cause the battery to
discharge.
. Before leaving the vehicle, make
sure that the light control switch
is turned to the
“ ” (off) position.
If the vehicle is left unattended
for a long time with the light
control switch set to a position
other than
“ ” (off) position, the
battery may be discharged.
NOTE
. Even if the key is removed from the
ignition switch, the lights can be illu-
minated by operating the light control
switch from the
“ ” (off) position to the
“ ” or “ ” position.
. If the driver’s door is opened while
the lights are illuminated and the key is
removed from the ignition switch, the
chirp sound informs the driver that the
lights are illuminated.
& Headlights
To turn on the headlights, turn the knob on
the end of the turn signal lever.
“ ” position
Instrument panel illumination, headlights,
parking lights, front side marker lights, rear
side marker lights, tail lights and license
plate lights are on.
“ ” position
Instrument panel illumination, parking
lights, front side marker lights, rear side
marker lights, tail lights and license plate
lights are on.
Instruments and controls
3-63
– CONTINUED –
3