Subaru 2013 Impreza - Manual (Page 55)

Black plate (53,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
8. To remove the child restraint system,
press the release button on the seatbelt
buckle and allow the belt to retract
completely. The belt will return to the
ELR mode.
WARNING
NEVER INSTALL A REARWARD FA-
CING CHILD SEAT IN THE FRONT
PASSENGER
’S SEAT. DOING SO
RISKS SERIOUS INJURY OR DEATH
TO THE CHILD BY PLACING THE
CHILD
’S HEAD TOO CLOSE TO THE
SRS AIRBAG.
NOTE
When the child restraint system is no
longer in use, remove it and restore the
ELR function of the retractor. That
function is restored by allowing the
seatbelt to retract fully.
! Installing forward facing child re-
straint
WARNING
Before installing a child restraint
system, be sure to confirm that the
seatback is securely locked into
place. Otherwise, in an accident,
serious injury or death could result.
1. Shake the seatback slightly to confirm
that it is securely locked into place.
– For 5-door models, it is possible to
check whether the seatback is locked
visually. If the seatback is locked into
place, the red colored unlocking mar-
ker which is attached to the bottom of
the lock release knob is invisible. For
details, refer to
“5-door models” F1-
11.
2. Prepare the rear seat head restraint
where a child restraint system is intended
to be installed in the following way.
– When a child restraint system is
installed on the window-side seating
position or the rear center seating
position of a 4-door model, remove
the rear seat head restraint. For de-
tails, refer to
“Head restraint adjust-
ment ” F1-8.
Store the head restraint in the trunk (4-
door models) or cargo area (5-door
models). Avoid placing the head re-
straint in the passenger compartment
to prevent it from being thrown around
in the passenger compartment in a
sudden stop or a sharp turn.
– When a child restraint system is
installed on the rear center seating
position of a 5-door model, raise the
rear seat head restraint to the ex-
tended position. Do not remove the
head restraint. For details, refer to
“Rear center seating position” F1-8.
3. Place the child restraint system in the
rear seating position.
WARNING
When you intend to install a child
restraint system on the rear center
seating position, if the child restraint
system does not fit snugly against
the contours of the rear center seat
cushion, install the child restraint
system on the window-side seating
Seat, seatbelt and SRS airbags
1-29
– CONTINUED –
1