Subaru 2013 Impreza - Manual (Page 207)

Black plate (211,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
Automatic climate control
operation (type B, C and D)
When this mode is selected, the fan
speed, airflow distribution, air-inlet control,
and air conditioner compressor operation
are automatically controlled. To activate
this mode, perform the following.
NOTE
. Operate the automatic climate con-
trol system when the engine is running.
. Even when cooling is not necessary,
setting the temperature much lower
than the current outlet air temperature
turns on the air conditioner compres-
sor automatically and the
“A/C” indi-
cator light on the control panel illumi-
nates.
& Type B
1. Turn the airflow mode selection dial
and fan speed control dial to the
“AUTO”
position.
2. Set the preferred temperature using
the temperature control dial.
NOTE
. Each function can be individually
set to the AUTO mode independently of
the other functions. Any function set to
the AUTO mode is controlled automa-
tically. Any function not set to the
AUTO mode can be manually adjusted
as desired.
. The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
3. To turn off the climate control system,
turn the fan speed control dial to the
“OFF”
position.
& Type C and D
1. Depress the “AUTO” button. The
indicator light “FULL AUTO” on the display
illuminates.
2. Set the preferred temperature using
the temperature control dial.
NOTE
. For type D, when the “DUAL” mode
button is pressed, separate tempera-
ture settings for the driver
’s side and
passenger ’s side can be enabled
(DUAL mode). To cancel the DUAL
mode, press the
“DUAL” mode button
again. The temperature setting for the
passenger
’s side becomes the same as
the setting for the driver ’s side.
. The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
. If you operate any of the buttons on
the control panel other than the
“OFF”
button, rear window defogger button
and temperature control dial(s) during
FULL AUTO mode operation, the
“FULL” indicator light on the control
panel will turn off and the
“AUTO”
indicator light will remain illuminated.
You can then manually control the
system as desired using the button
you operated. To change the system
back to the FULL AUTO mode, press
the
“AUTO” button.
3. To turn off the climate control system,
press the
“OFF” button.
Climate control
4-7
– CONTINUED –
4