Subaru 2013 Impreza - Manual (Page 303)

Black plate (313,1)
北米Model "A1140BE-A" EDITED: 2012/ 6/ 20
Gearshifts can be performed using the
shift paddle behind the steering wheel.
To upshift to the next higher gear position,
pull the shift paddle that has
“+” indicated
on it. To downshift to the next lower gear
position, pull the shift paddle that has
“–”
indicated on it.
To deselect the manual mode, return the
select lever to the
“D” position from the “M”
position.
CAUTION
Do not place or hang anything on
the shift paddles. Doing so may
result in accidental gear shifting.
NOTE
Please read the following points care-
fully and bear them in mind when using
the manual mode.
. If you attempt to shift down when
the engine speed is too high, i.e., when
a downshift would push the tachometer
needle beyond the red zone, beeps will
be emitted to warn you that the down-
shift is not possible.
. If you attempt to shift up when the
vehicle speed is too low, the transmis-
sion will not respond.
. You can perform a skip-shift (for
example, from 4th to 2nd) by operating
the shift paddle twice in rapid succes-
sion.
. The transmission automatically se-
lects 1st gear when the vehicle stops
moving.
. If the temperature of the transmis-
sion fluid becomes too high, the
“AT
OIL TEMP ” warning light on the combi-
nation meter will illuminate. Immedi-
ately stop the vehicle in a safe location
and let the engine idle until the warning
light turns off.
& Selection of “L” (if equipped)
“L” is for using engine braking when going
down a hill, etc. To select this mode, move
the selector lever from the
“D” position to
the “L” position.
When selected, the indicator “L” will
Starting and operating
7-21
– CONTINUED –
7