KBC Networks H.264 Encoder - Manual (Page 40)

Encoder User Manual
Manual-H264_ENC-Rev1207A
Copyright © KBC Networks 2012
Page 40 of 49 www.kbcnetworks.com
3.3.24 System: Firmware Upload
When “Firmware” is clicked, the interface will ask if you want to upgrade the
firmware. Clicking “Apply” will bring the user to the screen where the firmware files
will be input. Clicking “Apply” will not upgrade the firmware immediately as the
correct files must be found in order to upload. Clicking “Reset” will return to the
main menu. To upgrade, click “Apply” then click “Browse” to locate the two needed
files for firmware upgrade. You will require the images and md5 files in order to
successfully upgrade firmware. These files must be obtained from KBC and saved in
an accessible place to locate from the “Browse” button. Browse and locate then click
“Apply”. When the firmware begins to upload to the encoder, the LAN port activity
LED will flash rapidly and the encoder will display a process bar to indicate the
completion procedure. Do not turn off the encoder or disconnect the Ethernet cable
until after the GUI shows the process bar at 100%. The unit will then automatically
go through the reboot process. Expect the power LED to turn off and then re-
illuminate up to a minute later.