XTA DC1048 - Manual (Page 11)

Operator’s Manual DC1048 Integrated Audio Management Page 11
Installation
Electrical Considerations
The DC1048 has been manufactured to comply with your local power supply
requirements but, before connecting the unit to the supply, ensure that the
voltage (printed on the rear panel) is correct, and that a mains fuse of the correct
type and rating has been fitted.
If the unit’s GPIO terminals are not terminated with screened cables fast rising
transients from extreme RF fields, or ESD strikes over 4000 volts may cause
disturbance to the status LEDs on the unit. This will not affect audio performance
and will be corrected on the next power up cycle.
Make sure power outlets conform to the power requirements listed on
the back of the unit. Damage caused by connecting to incorrect AC
voltage is not covered by the warranty.
Mechanical Considerations
To ensure that this equipment performs to specification, it should be mounted in
a suitable rack or enclosure.
When mounting the unit in a rack or enclosure, ensure that there is adequate
ventilation. The cooling fan sucks cool air in through the LHS and blows warm air
out of the RHS of the unit through the ventilating grills.
Take care when mounting other equipment in the same rack.
Please also refer to the maintenance section on page 56 of this manual.