XTA DC1048 - Manual (Page 43)

Operator’s Manual DC1048 Integrated Audio Management Page 43
Appendix I: Updating Device Firmware
Overview
The firmware that runs the DC1048 hardware and controls the remote comms
may be updated using the loader engine built into
ICORE. Before explaining
how to update the firmware, please note that
ONLY ONE DEVICE MAY BE UPDATED AT A TIME – TURN OFF ALL OTHER
CONNECTED UNITS DURING THE UPDATE PROCEDURE!
The other devices on the network don’t need to be physically disconnected, just
turned off (NOT STANDBY – OFF!) so that
ICORE can determine which model it
has to update and confirm the update has been a success.
Note that DC1048 units cannot be updated over the audio transport
bridge (i.e. via a Ti-Breakout box) and must be directly connected to the
local USB on the front panel and the unit set to Master mode in the
COMMS menu.
Update Procedure Using ICORE
Before starting any updates…
SWITCH OFF ALL UNITS ON THE NETWORK (PROCESSORS, AMPS AND
BREAKOUTS) APART FROM THE ONE TO BE UPDATED!
CLOSE ALL OTHER OPEN PROGRAMS ON YOUR COMPUTER!
Now, in ICORE, select Tools Preset/Firmware Loader. You must be OFF-LINE
for this choice to be available. Make sure you have changed the Comms mode on
the unit to Master
Master Master Master so it enables the USB connection.