XTA DC1048 - Manual (Page 33)

Operator’s Manual DC1048 Integrated Audio Management Page 33
Additional Device Properties
All other properties that are not directly related to audio and real time control are
listed in the Properties window. These are:
General: ID: This is the unit’s address on the network(Read only)
Device Name: Click to edit the name of the unit
Firmware version: Currently running unit firmware (Read only)
Auto Update RTC: Sync the unit’s clock every time it’s on-line
GPI Mode: Select how the unit responds to changes through the
GPI port – the three modes of operation are explained on page 40
Transmit Preset: If enabled, any GPI triggered recalls will also be
echoed onto the RS485 network to trigger other DC1048s.
Memory Offset: Add an offset to the GPI recall location to enable
recalls above 1-4. This is also added to the TX’ed message if
enabled (see previous parameter)
LCD Contrast: Adjust viewing angle of unit’s display
On Delay: Set a countdown time to delay audio fading up when
unit is turned on.
LED Timeout: Set how long LCD and buttons remain at full
brightness after access
Options: Delay Multiplier: Set the step size used when adjusting any delay
times on the unit
Delay Units: Choose how delay times are displayed – in either time
or distance.
Security: Security Code: Last used code for local lock of front panel controls
System Lock: Current local lock state – may be changed remotely,
but see page 37 for details of how this works.