XTA DC1048 - Manual (Page 14)

Page 14 DC1048 Integrated Audio Management Operator’s Manual
6
: USB Connector
The front panel mounted USB connector is used for remote control and
configuration from a PC running
ICORE, as well as firmware updates. The USB
connection is configured under the “Comms” menu – see page 17 for more
information about going on-line. For details about upgrading firmware, see the
section on page 43.
7: Output Metering
The output meters show the level relative to the limiter threshold. The yellow LED
on each channel illuminating when the limiter threshold is reached. The red LED
indicates 4dB of gain reduction on that channel.
8: Preset Selection Buttons
In default mode, the UP( ) and DOWN ( )buttons will scroll through the list of
stored presets. Pressing OK will immediately load the selected preset. When in a
menu (having pressed a button on the left hand side of the panel) these buttons
will adjust the currently selected parameter, with “OK” setting it to the displayed
value and exiting the menu (after the 5 second preset delay).