Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 141)

RAID 1 Operations
ATCA-7350 Installation and Use (6806800G59G) 141
5. Select the hard disk that is set to the source disk. Enter Space for confirmation. The
window for selecting the RAID 1 creation mode is displayed as shown in Figure 7-7 .
6. Press <M> to specify the source disk. The window is displayed as shown in Figure
7-8 . For the source disk, Yes is displayed in RAID Disk and Primary Drive Status.
Figure 7-7 Window for Selecting the RAID 1 Creation Mode
 If you press <M>, the system saves the data in the current source disk. The target disk
copies the data in the source disk. If you press <D>, the system deletes the data from the
current source disk and creates a new RAID 1 array.
 In the window for selecting source disk and target disk, Slot Num 0 corresponds to HD0
as shown in
Figure 7-2 , and Slot Num 1 to HD1.
Figure 7-8 Window for Selecting the Source Disk and Target Disk