Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 177)

Troubleshooting
ATCA-7350 Installation and Use (6806800G59G) 177
Solution
To solve the problem, proceed as follows:
1. Make sure that this optional component is suitable for the ATCA-7350 suite.
For details, see Optional Components Supported by the ATCA-7350 on page 39 .
2. Make sure that the optional component is installed properly.
3. Make sure that any installed device or cable is not loose.
4. Re-install the optional component that is installed just now.
5. Replace the optional component that is installed just now.
For details, see Installing Blade Accessories on page 38 .
A.8.2 Number of DIMMs Is Inconsistent
Description
The number of the displayed system DIMMs is less than that of the installed physical DIMMs.
Solution
To solve the problem, proceed as follows:
1. Make sure that all DIMMs of correct type are installed in the slots properly.
2. Check for consistency of the size, rank and frequency of the installed DIMMs.
3. Re-install the DIMMs.
For details, see Installing the DIMM on page 42 .
4. Replace the DIMM.
For details, see Replacing the DIMM on page 44 .
5. If the problem persists, replace the ATCA-7350.
For details, see Installing and Removing the Blade on page 51 .