Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 145)

RAID 1 Operations
ATCA-7350 Installation and Use (6806800G59G) 145
12.Enter <Esc>. Select Exit the Configuration Utility and Reboot. See Figure 7-14 . Press
<Enter>. The system is restarted.
7.4 Activating RAID 1
When the SAS hard disk configured with RAID 1 properties is moved from a blade to another
blade, this hard disk is identified as in Inactive state. In this case, you need to activate the hard
disk or remove RAID 1 in the LSI BIOS configuration program. Otherwise, the hard disk cannot
be used.
Activating RAID 1
To activate RAID 1, proceed as follows:
1. In the POST stage of the system, the status of the moved hard disk is displayed as
"INACTIVE/OPTIMAL" when the following information is displayed:
LSI Logic Corp. MPT SAS BIOS
MPTBIOS-6.12.00.00(2006.10.31)
Figure 7-14 Window for Saving the Settings
After setting RAID 1 is complete and the system is restarted, RAID 1 is automatically
synchronized. It takes not less than 15 minutes to synchronize RAID 1. Do not power off or
restart the system in this process.