ATEIS UAPg2 - Manual (Page 138)

UAPG2 MANUAL
Version EN.24
138
Use third party over IP
Since UAPg2 software version 1.0.2.44, the UAPg2 can be control by third party equipment,
through the IP network.
Both third party over RS232 and UDP/IP work together.
The way to define the third party control is the same as with RS232. Please read "Define third
Party control" chapter on page 108.
On UAP side:
There is no parameter to set on the UAPg2. You just need to know the IP address of the UAPg2.
•
The UDP port used is always 19761.
On the third party device:
The IP address of the third party device must be on the same network than the UAPg2 ( by
default 192.168.100.x). If not, the IP routers must be set to establish links between the different
networks.
•
The UDP port used is always 19761.
Example:
As example, I use UDP Test Tool software which is free on internet.
In the third party window, copy the string of the command.
In the third party device, set its IP address to be on the same network then the UAP.
Write the UAP IP address as remote IP, with UDP port 19761.
The local UDP port is the same, 19761.