ATEIS UAPg2 - Manual (Page 67)

UAPG2 MANUAL
Version EN.24
67
Control: Here you can choose to pilot this fader with hardware control input.
1) Type of hardware connectors assigned to this software
analogue in.
2) Name of UAPG2 in the system which will have the assigned
connector. Here the 8 last control inputs of the UAPG2
named 1 are defined as analogue input. If you click none you
erase all previous assignment of this parameter in this
UAPG2.
3) Number of the connector assigned to the software
analogical input (CH = control input, rear of the UAPG2 and
FP front panel, front of the UAPG2)
Note: To define control input as logic (TTL) or Analogue input, see define control input .
Event: You can choose to assign this software logic in to an Event (after you will have the possibility
to select the state of this software logic input when the event is activated)
URC: When you use a URC you first define “Label” it is just a name that appears on the URC’s screen.
Here you can assign this software input to a specific label (after the UAPG2’s name and URC’s name,
all the label will be listed for each URCs).