ATEIS UAPg2 - Manual (Page 171)

UAPG2 MANUAL
Version EN.24
171
Connectors:
AUDIO OUTPUT (line out): This signal comes from the PPM's microphone to be connected in a
UAPG2 input (Shielded audio cable)
RS-485 MAIN-IN + AUDIO OUT (To UAPG2): It is the BUS 485 to be connected into the UAPG2. You
can also have access with this JB output to the PPM's microphone signal
(to be connected to a UAPG2 input)
Pin 1. RS-485 B
Pin 2. RS-485 A
Pin 3. Line in -
Pin 4. 24Vdc
Pin 5. Ground
Pin 6. Line in +
Pin 7. Line out -
Pin 8. Line out +
RS-485 SIDE: BUS 485 to connect URC
Pin 1. RS-485 B
Pin 2. RS-485 A
Pin 3. NC
Pin 4. 24Vdc
Pin 5. Ground
Pin 6 ~ 8. NC
LOCAL POWER (24VDC):To gives power to the JB through a local power supply
MASTER PPM (CAT5 5 pairs): To connect the PPM
Pin 1. Slave RS-485 A
Pin 2. 24Vdc
Pin 3. Master RS-485
Pin 4. Master RS-485 A
Pin 5. Line out + ( PPM Mic)
Pin 6. Line out - (PPM Mic)
Pin 7. Line in + (PPm speak.)
Pin 8. Line in – (PPm speak.)
Pin 9. Ground
Pin10. Slave RS-485 B
RS-485 MAIN-OUT (To next Master): To connect another JB (daisy-chain)
Pin 1. RS-485 B
Pin 2. RS-485 A
Pin 3. NC
Pin 4. 24Vdc
Pin 5. Ground
Pin 6 ~ 8. NC