ATEIS UAPg2 - Manual (Page 75)

UAPG2 MANUAL
Version EN.24
75
Check UAPG2 version
To know which versions are loaded in the devices and which version are available with the UAPG2
software:
•
Choose menu: > Help > Version
If you have trouble to read version it is probably due to the fact that the system is not configured. It
means that the software doesn't know how many UAPG2 are connected to it and the UAPG2s
doesn't know their place in the network (even if you have one UAPG2) to set up the system:
1) clean MCU
2) make a simple design (just define UAPG2 system)
3) compile it and load it. (If the system is not configured, the software will ask you if you want to do
it. Click [yes]) The software will check if the version between the AP and the UAPG2 are matching.
and tell you if it is not the case.
After those Steps you can read the version.
Note: During the Store process, the software verify the different versions (DSP, MCU, NET, PM and
URC) If the version are not correct, a message appears.
Connect UAPG2G » to your PC
Launch the UAPG2 software
•
Choose menu: > Help > Version
•
Click
Firmeware Ver: if red indicates that MCU has to be updated.
DSP Ver: if red indicates that DSP has to be updated.
Version mismatch is displayed in red, indicates that you have to update the Firmware
When you have URC or PPM defined and connected you can also check if versions are OK.
Note : Updating the UAPG2 software sometimes makes necessary to update the UAPG2's firmware
also.
Updating the LAP software sometimes makes necessary to update the LAP's firmware also.