ATEIS UAPg2 User Manual
Page 74
UAPG2 MANUAL
Version EN.24
74
•
Then draw your design by drag and
drop the UAP icon to the design area.
For each UAP the "Configure Modules"
window ask you about the Audio modules.
As the system is configured,
the Inputs/Outputs choice appears already
correctly. (Check it)
To send audio between the UAP,
you have to use the Digilinks components.
You can send 16 channels at 48kHz (5 at 96kHz)
from each UAP to the next UAP.
Now your system is ready.
- The Ethernet led lit on the master.
- All the link led lit.
Machine Configuration Error
If a Digilink is absent or broken, this error message appears:
-Check your RJ45 wiring.
-Look on the front led,
-If a link led is off (the others led should blink), it means there is a problem with the
input Digilink.
-If the power led blink in red and green, that means the configuration of this UAP
doesn't match its the physical connection.
When you do something to resolve the problem (like exchange a cable), the UAPs need some times
to get the system in a normal state. You have to wait several seconds. I can also try to store again the
configuration to wake up the system.